Introduction to Bushings

Oct 14, 2025 Leave a message

In moving parts, wear occurs due to prolonged friction. When the clearance between the shaft and the bore wears to a certain extent, the parts must be replaced. Therefore, designers choose materials with lower hardness and better wear resistance for bushings or bushings to reduce wear on the shaft and housing. Replacing the bushing or bushing when it wears to a certain degree saves on the cost of replacing the shaft or housing. Generally, bushings use an interference fit with the housing and a clearance fit with the shaft, because wear is inevitable, and the only solution is to extend its lifespan. Shaft parts are relatively easy to machine. Some new designers dislike this design, believing it increases manufacturing costs, but over time... After use, maintenance still requires modification using this method, but modification can easily reduce the equipment's precision. The reason is simple: secondary machining cannot guarantee the correct centering of the seat hole. Bushings are used to replace rolling bearings (in fact, bushings are also a type of sliding bearing) in applications with low speeds, high radial loads, and high clearance requirements (such as camshafts). The material must be low in hardness and wear-resistant. The inner hole of the bushing is ground and scraped to achieve high fitting precision. There must be oil grooves on the inner wall for lubrication. Lubrication of the bushing is crucial; dry grinding will quickly damage the shaft and bushing. It is recommended to scrape the inner wall of the bushing during installation, leaving many small pits to enhance lubrication. Different models of bushings and bushings are selected based on different working conditions. The most important conditions are: pressure, speed, pressure-speed product, lubrication status, and load characteristics. Bushing selection is available in the Quick & Easy Automation selection guide.

 

Wrapping the valve stem allows for easy replacement when worn. Without a bushing, worn parts would need to be replaced. Therefore, the bushing needs to be replaced (the bushing's hardness is reduced during design, making it a wear-bearing component in the friction pair). It is easy to process, has low replacement costs, and is easy to replace. Of course, its guiding function is also secondary.