Why Do Holes Become Distorted When Metal Parts Are Bent?
Discover why holes near bend lines may change shape and how proper design and tooling can help improve dimensional accuracy.
Have you ever tried to insert a bolt or pin through a metal bracket, only to find that the hole is no longer perfectly round after bending?
In custom sheet metal stamping, holes are often placed near flanges, edges, and formed sections for mounting, positioning, or fastening.
However, bending changes the shape and position of the surrounding material. If a hole is too close to the bend area, it may become oval, shift slightly, or lose its original dimensions.
Understanding why this happens can help designers reduce manufacturing problems and achieve better assembly results.
1. Why Can Round Holes Become Oval During Bending?
When sheet metal is bent, the material on the outside of the bend is stretched, while the material on the inside is compressed.
This movement does not occur only along the bend line. It can also affect the nearby flat areas, depending on the material, thickness, and bend radius.
If a pierced hole is located within this deformation area, the material around it may move or stretch. As a result, the original round hole can become oval, change in diameter, or shift slightly from its intended position.
This can cause problems during assembly, especially when the hole is used for a locating pin or a close-fitting fastener.
2. How Far Should a Hole Be from the Bend Line?
The distance between a hole and a bend line is an important factor in sheet metal design.
There is no single spacing rule that works for every metal part. The suitable distance depends on several factors, including:
- Sheet thickness: Different thicknesses can produce different material movement during bending.
- Inside bend radius: The bend radius affects how the material stretches and compresses.
- Material properties: Different metals have different levels of strength and ductility.
- Hole size and position: Larger holes and holes located closer to the bend area may require additional design consideration.
In general, keeping the hole outside the main deformation area can help reduce distortion. For critical dimensions, the hole-to-bend distance should be reviewed according to the actual part design and forming conditions.
3. How Can Hole Distortion Be Reduced?
When a hole must be positioned close to a bend line, designers and tooling engineers may consider different approaches depending on the part structure and production requirements.
- Adjusting hole position: Moving the hole farther from the bend area can reduce the effect of material deformation.
- Adding a relief feature: A suitable relief slot or cutout may help accommodate material movement near the bend. Its shape and position should be checked against the part's structural requirements.
- Post-forming piercing: Piercing the hole after bending can help reduce distortion caused by the forming process. Accurate positioning and tooling design are still important.
- Using a slotted hole: In some applications, an oblong hole can provide additional assembly clearance when the design allows it.
Not every solution is suitable for every component. The best approach depends on the required hole accuracy, part geometry, material, and production process.
4. What Should You Check Before Ordering Custom Metal Parts?
When ordering stamped or bent metal components, checking the following details before production can help reduce misunderstandings and assembly issues.
- Distance from the hole edge to the nearest bend line
- Hole function: fastener clearance, locating pin, or cable passage
- Material grade and sheet thickness
- Inside bend radius and forming direction
- Required hole diameter and positional tolerances
- Whether hole dimensions refer to the condition before or after final bending
If a complete CAD drawing is not available, clear product photographs or physical samples with marked dimensions can also help communicate the part requirements.
5. Why Should Hole Position Be Considered Early in Production?
In custom stamped metal parts, hole positions, bend locations, and final assembly dimensions are often closely related.
A hole that looks correctly positioned on a flat drawing may behave differently after the material is formed. Reviewing these details before tooling and production can help identify potential issues earlier.
For manufacturers and buyers, clear drawings and well-defined dimensional requirements make it easier to evaluate the part structure, production sequence, and final inspection criteria.
Final Thoughts
Hole distortion near bend lines is related to material movement during metal forming. Considering hole spacing, material properties, bend radius, and the production sequence at the design stage can help improve dimensional accuracy and make final assembly more reliable.






