Dimensional Accuracy Of Stamped Parts

Nov 05, 2025 Leave a message

The accuracy of stamped parts typically reaches IT8 to IT12 (international tolerance grades), with specific values ​​ranging from ±0.05mm to ±0.5mm. The exact accuracy depends on the material, die, equipment, and process control level. The following is a detailed analysis:

 

Material Influence:

Soft materials (such as aluminum and copper) have low springback, achieving a precision of ±0.05mm to ±0.1mm; Hard materials such as high-strength steel have high springback, typically achieving a precision of ±0.1mm to ±0.3mm.

 

Die Factors:

Precision progressive dies can stably achieve high precision of ±0.02mm to ±0.05mm; Ordinary single-operation dies typically achieve a precision of ±0.1mm to ±0.3mm.

 

Equipment and Process:

High-speed punch presses (≥800 times/minute) with servo control can achieve a precision of ±0.03mm; Traditional mechanical punch presses typically achieve a precision of ±0.1mm to ±0.5mm.

 

Industry Application Standards:

Precision parts such as electronic connectors require a precision within ±0.02mm; Automotive structural parts typically accept a tolerance of ±0.2mm to ±0.5mm; Ordinary parts such as appliance housings allow a tolerance of ±0.3mm to ±1mm.

 

Key measures to improve accuracy:

Use optical alignment molds (improving accuracy by over 30%); Add a shaping process (reducing errors to 50% of the original value); Use precision sheet metal with a thickness tolerance of ±0.01mm.