SHANGERS / CUSTOM STEEL STAMPING
Steel Parts Made Around the Assembly
A stamped steel part is often a small item in a larger assembly, but its fit can affect how the whole assembly goes together. A hole in the wrong position, a bend that leaves too little clearance, or an edge facing the wrong direction can create extra work during installation.
SHANGERS supplies custom stamped steel parts based on customer drawings or samples. The examples on this page are manufacturing references, not a fixed-size stock range. Each order needs an agreed specification for the material, geometry and finish.
Start with the Surfaces That Must Fit
When discussing a new part, identify where it sits, where it is fastened and which areas must remain clear. These details are more useful than an overall length and width alone. For a flat part, hole locations and the seating surface may be the main concerns. For a formed part, the distance between faces and the relationship between holes and bends may also need attention.
Mounting features: identify the holes or slots used for fastening or location.
Formed geometry: mark the bend direction and any clearance needed around adjoining parts.
Contact edges: indicate edges that touch cables, plastic components or surfaces handled during assembly.
Visible faces: distinguish cosmetic surfaces from areas concealed after installation.
Define the Steel and Finish Together
"Steel" alone is not a complete material specification. Please state the grade and sheet thickness where these are already defined. If an existing sample is the starting point, tell us which material information is known and which details still need confirmation.
The surface requirement should also reflect the intended use. Describe whether the part operates indoors or in a damp environment, whether its appearance matters, and whether a coating is specified. A silver appearance in a photograph does not identify the steel grade or prove a particular corrosion-resistance level.
Details to Confirm Before Production
| Item | Information for your part |
|---|---|
| Material | Steel grade and sheet thickness, confirmed for the order |
| Dimensions | Overall size plus mounting, locating and mating dimensions |
| Forming requirements | Bend direction, angles and clearance where applicable |
| Edges and surfaces | Burr limits, relevant edge direction and cosmetic faces |
| Finish | Required treatment and any associated acceptance criteria |
| Quantity | Trial quantity and expected repeat-order volume |
No universal dimensions or tolerance are assigned to the samples shown here. The approved drawing and order specification define the finished part.
Review a Sample in Its Intended Position
For a new design, checking the part against its mating components can reveal issues that a photograph cannot. Confirm that fasteners enter correctly, formed faces do not interfere with nearby parts, and the seating area meets the assembly requirement. Record any changes against the drawing revision so that a later order does not rely on an outdated sample.
Questions About a Custom Order
Can I start with a sample instead of a complete drawing?
Yes. Send clear photographs, the dimensions you know and a short description of how the part is used. A physical sample or additional measurements may be needed before the final specification can be agreed.
Can a similar-looking part replace my existing component?
Appearance alone is not enough. Check the material, thickness, mating dimensions and finish before treating two parts as interchangeable.
What information helps with an initial quotation?
A part drawing or photographs, approximate size, required quantity and any known material or finish requirements are a useful starting point. Mark unknown details rather than guessing them.
Discuss Your Steel Stamping Project
Send the part reference and tell us what it must fit. If you are replacing an existing component, include the feature that needs to stay unchanged and any problem you want to resolve.
Contact SHANGERS about your part · View other metal stamping references
Hot Tags: Custom Stamped Steel Parts for Assembly Applications, ChinaCustom Stamped Steel Parts for Assembly Applications manufacturers, suppliers, factory, stamped metal part, metal stamping part, precision metal stamping part, precision metal stamping, stamped titanium part, high precision metal stamping







